R6 Message Net banner
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
So I recently rebuilt the motor on my R6, total nightmare. I went all the way down to the bare block because I thought I was going to bore the motor, but I decided not to. Got everything back together and went to do a test drive and the bike does move when I give it more throttle (video link down below). I didn’t take out the transmission, I just disassembled the clutch when I was doing the rebuild, so I’m leaning towards it being the clutch. The bike will freely roll when it’s off in gear with slight resistance, and when it’s on I’ll put it into first and the wheel will the start spinning when it’s on the rear stand. I tried adjust the clutch lever and the clutch line by the basket but I want to if anyone may have any suggestions before I take everything back apart.
-Thx
Yamaha r6 clutch issues?
 
1 - 1 of 1 Posts
Top