R6 Message Net banner
1 - 2 of 2 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi Guys
Hoping someone can help with this. Recently rebuilt an 01 R6 motor including using a gearbox from the 03 as this is a better quality than the previous gen and it is the same dimensions and fit straight in , all gears engage and everything is tight and within spec BUT will not engage with the motor . We have even put the old gearbox back in and this still will not engage, it just spins . Any help gladly appreciated.
Regards
 

·
Registered
Joined
·
2 Posts
Check the clutch is installed correctly. Use a parts diagram. Also ensure spring plate is fit into steel plate groves in the centre hub. hope that makes sense
 
1 - 2 of 2 Posts
Top