R6 Message Net banner

1 - 7 of 7 Posts

·
Registered
Joined
·
208 Posts
Discussion Starter #1
Hey guys wats happening, I need some advice on sumting, Im adding on some Powerstuntworx Axle Slderz on my 04' R6, I ordered a pair for the rear because the axle is hollow right. So when I mounted it up Im saying to myself, it sure would be cool to have a pair in the front, the problem is, the axle up front is hollow except for that bolt on the right side that screws in, I took out that screw/bolt and tried out the Axle Sliderz in the front and it fit. My question is would it be safe to ride without that screw/bolt on the front wheel or would it be safe replacing that screw/bolt with the pair of Axle sliderz????. Any feedback would be greatly appreciated. I put it in the stunters section but havent gotten any response. Thanks
 

·
F3 to R6 to 675...Whooah!
Joined
·
483 Posts
cristianr6 said:
My question is would it be safe to ride without that screw/bolt on the front wheel...
That bolt is being held on with almost 70 ft/lbs of torque. I think it would be safe to say it's needed.
 

·
F3 to R6 to 675...Whooah!
Joined
·
483 Posts
Thrak said:
what color is your bike?

if its black, can I get the mids if they arent rashed to badly?


:D
:spit
 
1 - 7 of 7 Posts
Top