R6 Message Net banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I tried to wire up my ignition using a toggle switch instead of the keyed ignition on my 03 r6 and must have burned something up. I heard a sound come from around the ECM when I did it and the ecm just hums now and the engine light stays on. It will turn over but not start. I bought another ecm and put my keyed ignition back on, but still will not start (the new ecm does not hum though). I put it in diag mode and there was a diag code 30 which I think says open current to coil #1 but not sure. Any help would be much appreciated.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top