R6 Message Net banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hello everyone. I’m new to this forum. I have a 2003 R6 and had to replace my fuel pump. After doing so, I couldn’t get the bike to start, only turns over.
I have a few codes come up when I go into diagnostics; code 30, 22 and 13.
I know what the codes are And have checked the sensors resistance and they seem good.
I have a Woodcraft keyless harness so I don’t think I can use the owners manual method of turning the on/off switch off and back on to clear cuz the keyless harness uses the on/off switch as the key on position.
Can anyone help me with clearing the codes another way??
 
1 - 1 of 1 Posts
Top