R6 Message Net banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey all. Bought it a few weeks ago, and its been all good until today.

I was riding through the city after about an hour of riding when it threw a CEL and power dropped, and she eventually stalled out. Shut it off, started back up fine and I got it home.

I looked through the forum and found what all the codes mean. I read up on how to get to diagnostic mode, and did that.

This is where I might be a bit retarded, but when I did the above, I get to diagnostic modes and it goes 1 through 60. I am inferring that goes through each check, but how do I know which one threw the CEL? As I cycled, there were a couple of codes that read "ON", where as the others were just numbers. Would I be correct in assuming that the ones that read on are the stored fault codes?
 
1 - 1 of 1 Posts
Top