08 LED Signals/Electrical

[Atrizzle]

I recently installed two flush mounted front turn signals which are LED. Once they were on they all lit up fine, however, they did blink faster than they previously did. I just installed a fender eliminator kit and I had LEDs put into my rear passenger pegs to use as the rear turn signals. After doing so andcompleting the wiring (with the stock harnesses even) the back ones light up fine (still blink fast) but now the fronts do not fully light up, plus on my instrument panel, both the left and right blinker indicators are permanently lit, just a bit dimmer. Any help would be greatly appreciated.Should I be using any type of load resistors, etc?

[R6Dogg]

What I did was replace the flash relay. That took care of mine flashing fast. I bought it from tobefest and was only $20.

[je_rrt]

I'm having the exact same problem. Let me know if this solution worked for you, too.

[fellows613]

where did you get the flush mounts? I just got a silver 08 r6 and want to get flush mount LED signals.

[je_rrt]

amazon.com

[Atrizzle]

Got em off ebay. Just regular ole smoked lens flush LEDs, compliment the bike and the look I am going for on it very well.