Bike Won't Start After Fixing Elec. Prob.-Help

[Pants711]

'00 R6. Complete Power Failure. Discovered a fried out connector. I clipped it, replaced all of the connectors, hooked it back up, had power. Turned it over, no problems.

Put the tank (Which wasn't completely removed, just set on a table next to the bike) & Seat back on, backed it out of garage, now it won't turn over. acting like it is out of gas? Plenty of gas, battery is showing 12.34V.

Took the tank back off to see if the petcock was bumped closed (NO), checked for bent/twisted fuel line (NO). put tank back on again, still no start. Any Ideas? Thanks for any help you fine folks can provide....-Pants

[Wicked1]

I have the same problem bro. I think the problem to my solution is the Starter Relay. Your Problem ma lie with a disconnected plug or fried R/R...but good luck getting advice from other ppl on here, Ive posted my problem here since last week, and no one cares lol

[Pants711]

Turns out my starter relay was bad after all....

[Wicked1]

Originally Posted by Pants711

Turns out my starter relay was bad after all....

LMAO! wow, the Starter Relay was your problem, I finnally replaced my SR with a more exspensive aftermarket one, and my bike STILL doesnt turn over lol