Content Wrapper

[lilhelmet]

Same here, I had a little get off & now I want to replace it so it doesn't look bad. Thanx for the write up, now I can change it. Any idea yet of what the Torx bit size is? I don't think I'll have it so I'd like to go buy it before I start, I hate stopping in the middle of a project to go buy tools

Edit: I just changed this out, and I have a few tips, make sure you can get good torque on the stator & sator bracket screws cause they're in there good from the factory with loctite, and you'll strip the heads if you're not careful like I did on the bracket screw . Luckily my dad was around to bail my ass out & cut a slot in the head & used a ratchet driver with a flat head to get it out. Now it's an allen, much easier. Just take your time & get it right or you'll mess up or forget something.